Some nectar will overflow and come out of the tube but this will keep air out of the adapter and tube, then your feeder is ready to go! Push the tube and adapter into the bottle in a twisting motion. Be sure to fill the bottle all the way to the top rim of the bottle. You can place the bottle anywhere you can hang a plant… along a fence (with an extension bracket or hanger), an overhang, trellis, under an arbor, etc.īefore filling your bottle with nectar clean the inside of the bottle thoroughly (see cleaning below). Now all there is to do is to make a hook at the bottle’s “bottom end”, which will be at the top when you fill and turn the bottle upside-down. You can use some temporary electrical tape to hold the wire to the bottle for the next step. Then, holding the neck with the wire wrapped around it, start to wrap the wire down the rest of the bottle in a spiral fashion, making enough spiral rings around the bottle to firmly hold it. A hand-held pair of vise grips would also be helpfulįirst, wrap the copper wire around the neck of the bottle at least 3 times.Apply spray in several thin coats, allowing each coat to dry in between applications. Most wire can be painted with the exception of zinc-plated galvanized. Patina finishers allow you to speed up this process to an hour or two. Steel will rust, brass will tarnish to a soft brown, and copper will turn blue or green. Patina finishes: If you expose copper, steel or brass to the elements for long enough, they will oxidize or patinate. This is due to a corrosion-resistant zinc plating.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |